13 Comments

  1. Bone Head
    April 29, 2016 @ 10:57 am

    I especially like the extra fancy duct tape clamping you used :))

    Reply

    • eric
      August 30, 2017 @ 5:58 am

      I am Sharing my personal experience about one of the wood working plan i am using for my project. it contains all woodworking plans include workbench plans, shed plans, chair … blueprints and detailed instructions for building all kinds of wooden,
      Check here to get all the wood working plans >> ( go2l.ink/wood )
      .

      Reply

  2. Rodolfo
    April 29, 2016 @ 12:42 pm

    Really nice bit storage
    Gretting .from Costa Rica

    Reply

  3. Woodman22
    April 29, 2016 @ 1:05 pm

    Now I know you made a drill bits case a couple of years ago, what made you think of making a another one?????

    Reply

  4. Paul
    April 29, 2016 @ 3:21 pm

    A quick tip: a safer method for separating the lid from the box is to cut all the way through the two short ends first.
    Then lower the blade to approximately 1/6 inch less than the thickness of the material used for the sides. Finally just use a utility knife to separate the lid. A little cleanup sanding and you’re done. It’s safer because the the lid and box cannot pinch the blade possibly causing kick back.

    Reply

  5. Stuart
    April 30, 2016 @ 7:04 am

    Paul beat me to it. To separate the lid, set the blade to just not cut all the way through the sides of the box (I normally do it the same depth on all four sides) and then use a knife to separate lid from base.

    As an added bonus, if you show it to students (I teach tech) before you separate lid from base, it really confuses them and gets them thinking about how to open the box!

    Reply

  6. Koen
    April 30, 2016 @ 7:43 am

    Cool project! I used to have a plastic container filled with unorganized drill bits, but I went ahead and built one of these and now I’ll never have to search for the right bit again! I modified the measurements because I have metric drill bits and I used scrap wood. Your video’s inspire me! Greetings from the netherlands!

    Reply

  7. Woodman22
    May 9, 2016 @ 2:58 pm

    You can get some really nice drill bits at Harbor freight and a lot more good stuff for not a lot of money….

    Reply

  8. Eduardo
    May 26, 2016 @ 12:23 am

    Muito legal, parabéns….

    Reply

  9. Louis
    July 7, 2016 @ 10:53 am

    Great project. But PLEASE. PLEASE put a riving knife on that saw blade. Kickback is real amd potentially fatal

    Reply

    • Dennis
      December 22, 2016 @ 7:08 pm

      The Riving knife is installed…

      Reply

  10. John
    September 26, 2017 @ 2:46 pm

    Don’t wish to sound old fashioned??? But how about a tennon saw

    Reply

  11. Fran Andersen
    November 6, 2017 @ 6:24 am

    Does anybody make and sell these drill boxes??

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *