1. Marshall
    October 7, 2016 @ 3:38 pm

    And it even uses ye olde pocket screw joinery!


  2. Ângelo
    October 7, 2016 @ 3:49 pm

    Muito bom, parabéns, estou no Brasil.


  3. Ben Estell
    October 7, 2016 @ 4:47 pm

    That would be great for locking up Hillary Clinton!


    • Conservative Dumbass
      February 15, 2018 @ 5:04 pm

      You. Are. An. Idiot.


      • Robert
        March 15, 2018 @ 6:59 am

        I think it would be great to lock up that crazy lady. I’m also glad you can insult someone for disagreeing with you, especially to defend “that” woman.


  4. silva
    October 18, 2016 @ 5:26 am



  5. Phoenix Jackson
    August 10, 2017 @ 4:24 am

    Great tutorial – got me out of a real fix and saved me heaps of time with working out the design. Thanks.

    The only modifications I made to this was to the crossbeam at the bottom and the ‘feet’. I built the uprights and crossbeam at the same time, sandwiching the crossbeam between the two thin upright pieces, using two short 2×4 pieces (one above, one below the crossbeam). I felt this gave it extra vertical force strength. In the feet I drilled a 20mm hole near the end of each ‘foot’ to allow for a long hooked spike (similar to a tent peg) to be hammered through into soft ground to prevent any movement.


  6. James West
    May 1, 2018 @ 10:27 am

    Nice job! Do you ever use it?


  7. annomyous
    May 1, 2018 @ 4:31 pm

    what a freaking dumbass, are u an idiot or did u just get dropped as a child you DOWNIE.


  8. anonymous
    May 1, 2018 @ 4:34 pm

    naa jk lol.


  9. Kat
    August 14, 2018 @ 7:34 am

    I already have plans on how to modify this for easy breakdown and transportation. I think, for aesthetics, I’m going to go with 100% dowel (and glue) construction and skip the screws. The knee brace needs to be slotted into the uprights.


Leave a Reply to Kat Cancel reply

Your email address will not be published. Required fields are marked *